Fastening a Seat Belt

Honda Crosstour / Honda Crosstour 2010-2024 Owner's Manual / Safe Driving / Seat Belts / Fastening a Seat Belt

After adjusting a front seat to the proper position, and while sitting upright and well back in the seat:

 Adjusting the Seats

1. Pull the seat belt out slowly.

1. Pull the seat belt out slowly.

2. Insert the latch plate into the buckle, then

2. Insert the latch plate into the buckle, then tug on the belt to make sure the buckle is secure.

­ Make sure that the belt is not twisted or caught on anything.

Fastening a Seat Belt

No one should sit in a seat with an inoperative seat belt or one that does not appear to be working correctly. Using a seat belt that is not working properly may not protect the occupant in a crash.

Have a dealer check the belt as soon as possible.

Never insert any foreign objects into the buckle or retractor mechanism.

3. Position the lap part of the belt as low as

3. Position the lap part of the belt as low as possible across your hips, then pull up on the shoulder part of the belt so the lap part fits snugly. This lets your strong pelvic bones take the force of a crash and reduces the chance of internal injuries.
4. If necessary, pull up on the belt again to remove any slack, then check that the belt rests across the center of your chest and over your shoulder. This spreads the forces of a crash over the strongest bones in your upper body.

■Adjusting the Shoulder Anchor

The front seats have adjustable shoulder anchors to accommodate taller and shorter occupants.

1. Move the anchor up and down while

1. Move the anchor up and down while holding the release button.
2. Position the anchor so that the belt rests across the center of your chest and over your shoulder

Fastening a Seat Belt

WARNING

Improperly positioning the seat belts can cause serious injury or death in a crash.

Make sure all seat belts are properly positioned before driving.

To release the belt, push the red PRESS button then guide the belt by hand until it has retracted completely.

When exiting the vehicle, be sure the belt is out of the way and will not get caught by closing the door.

Adjusting the Shoulder Anchor

The shoulder anchor height can be adjusted to four levels. If the belt contacts your neck, lower the height one level at a time.

After an adjustment, make sure that the shoulder anchor position is secure.

■Advice for Pregnant Women

If you are pregnant, the best way to protect yourself and your unborn child when driving or riding in a vehicle is to always wear a seat belt and keep the lap part of the belt as low as possible across the hips.

Advice for Pregnant Women

Advice for Pregnant Women

Each time you have a checkup, ask your doctor if it is okay for you to drive.

To reduce the risk of injuries to both you and your unborn child that can be caused by an inflating front airbag:

• When driving, sit upright and adjust the seat as far back as possible while allowing full control of the vehicle.
• When sitting in the front passenger’s seat, adjust the seat as far back as possible.

    See also:

    Playing Bluetooth® Audio
    Your audio system allows you to listen to music from your Bluetooth®-compatible phone. This function is available when the phone is paired and connected to the vehicle’s Bluetooth® HandsF ...

    Replacing Light Bulbs
    When replacing, use the following bulbs. High beam headlight: 60W (HB3 for halogen bulb type) Low beam headlight: 55W (H11 for halogen bulb type) NOTICE Halogen bulbs get very hot when lit. Oil ...

    LaneWatchTM
    Is an assistance system that allows you to check the passenger side rear areas displayed on the audio/information screen when the turn signal is activated to the passenger’s side. A camera in ...