Replacing Light Bulbs

Honda Crosstour / Honda Crosstour 2010-2024 Owner's Manual / Maintenance / Replacing Light Bulbs

When replacing, use the following bulbs.

High beam headlight: 60W (HB3 for halogen bulb type)
Low beam headlight: 55W (H11 for halogen bulb type)

NOTICE

Halogen bulbs get very hot when lit.

Oil, perspiration, or a scratch on the glass can cause the bulb to overheat and shatter.

The headlight aim is set by the factory, and does not need to be adjusted. However, if you regularly carry heavy items in the cargo area or tow a trailer, have the aiming readjusted at a dealer or by a qualified technician.

When replacing a halogen bulb, handle it by its base, and protect the glass from contact with your skin or hard objects. If you touch the glass, clean it with denatured alcohol and a clean cloth.

The exterior lights’ inside lenses (headlights, brake lights, etc.) may fog temporarily after a car wash or while driving in the rain. This does not impact the exterior light function.

However, if you see a large amount of water or ice accumulated inside the lenses, have your vehicle inspected by a dealer.

■High Beam Headlight

Passenger side

Passenger side
1. Remove the engine coolant reservoir.

2. Push the tab to remove the coupler.

2. Push the tab to remove the coupler.
3. Rotate the old bulb to the left to remove.
4. Insert a new bulb into the headlight assembly and turn it to the right.
5. Insert the coupler into the connector of the bulb.

■Low Beam Headlights

1. Turn the steering wheel all the way to the

1. Turn the steering wheel all the way to the opposite side from the light being replaced.

Passenger side: Turn the steering wheel to the left.
Driver side: Turn the steering wheel to the right.

2. Remove the holding clip and screw, and pull the inner fender back.
3. Push the tab to remove the coupler.
4. Rotate the old bulb to the left to remove.
5. Insert a new bulb into the headlight assembly and turn it to the right.
6. Insert the coupler into the connector of the bulb.

Insert a flat-tip screwdriver, lift and remove the central pin to remove the clip.

Insert the clip with the central pin raised, and push

Insert the clip with the central pin raised, and push until it is flat.

Fog Light Bulbs

See also:

Accessories and Modifications
WARNING Improper accessories or modifications can affect your vehicle’s handling, stability, and performance, and cause a crash in which you can be seriously hurt or killed. Follow all instru ...

Display Setup
You can change the brightness or color theme of the audio/information screen. ■Changing the Screen Brightness 1. Press the DISP button to go to the Settings screen. 2. Rotate to select Sy ...

If the Malfunction Indicator Lamp Comes On or Blinks
Reasons for indicator lamp to come on or blink  - Comes on when there is a problem with the engine emissions control system, or the fuel fill cap is missing, or loose.  - Blinks when en ...