Changing the Rear Wiper Blade Rubber

Honda Crosstour / Honda Crosstour 2010-2024 Owner's Manual / Maintenance / Checking and Maintaining Wiper Blades / Changing the Rear Wiper Blade Rubber

1. Raise the wiper arm off.

1. Raise the wiper arm off.

2. Pry on the edge of the lock tab using a flattip

2. Pry on the edge of the lock tab using a flattip screwdriver to push it up.
- Wrap the flat-tip screwdriver with a cloth to prevent scratches.

3. Slide the wiper blade out from the end with

3. Slide the wiper blade out from the end with the indent.

NOTICE

Avoid dropping the wiper arm; it may damage the rear window.

4. Remove the retainers from wiper blade and

4. Remove the retainers from wiper blade and mount to a new rubber blade.

5. Slide the wiper blade onto the holder.

5. Slide the wiper blade onto the holder.
- Make sure it is engaged correctly, then install the wiper blade assembly onto the wiper arm.

    See also:

    Reporting Safety Defects
    In the U.S. If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration ...

    Tires
    To safely operate your vehicle, your tires must be the proper type and size, in good condition with adequate tread, and correctly inflated. The following pages give more detailed information on how ...

    Using the Lock Tab
    Locking a door Pull the lock tab. Unlocking a door Push the lock tab in. Using the Lock Tab When you lock/unlock either front door using the master door lock switch, tailgate, glass hatch, and ...