Rear Wiper/Washer
The rear wiper and washer can be used when the ignition switch is in ON .
Wiper switch (OFF, INT, ON)
Change the wiper switch setting according to the amount of rain.
Washer
Sprays while you rotate the switch to this position. Hold it to activate the wiper and to spray the washer. Once released, it stops operating after a few more sweeps.
Operating in reverse
When you shift the transmission to with the front wiper activated, the rear wiper operates automatically as follows even if its switch is off.
Wipers and Washers
If the wiper stops operating due to any obstacle such as the build-up of snow, park the vehicle in a safe place.
Rotate the wiper switch to OFF, and turn the ignition switch to ACCESSORY or LOCK , then remove the obstacle.
The wiper motor is equipped with a breaker that may stop motor operation temporarily to prevent an overload. Wiper operation will return to normal within a few minutes, once the circuit has returned to normal.
See also:
Preparing to Drive
You still need to exercise the same care when accelerating, steering, and braking
that you would in a twowheel drive vehicle.
1. Make sure all windows, mirrors, and outside lights are clean and uno ...
HFL Menus
The ignition switch must be in ACCESSORY
or ON
to use HFL. You can operate HFL by
voice when on the PHONE screen. Below is the flow chart showing available voice
commands.
HFL Menus
...
High-Mount Brake Light Bulb
High-mount brake light bulbs are LED type. Have an authorized Honda dealer
inspect and replace the light bulbs. ...