Cruise Control
Maintains a constant vehicle speed without having to keep your foot on the accelerator. Use cruise control on freeways or open roads where you can travel at a constant speed with little acceleration or deceleration.
Cruise Control
WARNING
Improper use of the cruise control can lead to a crash. Use the cruise control only when traveling on open highways in good weather.
It may not be possible to maintain a constant speed when driving uphill or downhill. When not using cruise control: Turn off cruise control by pressing the CRUISE button.
To Set the Vehicle Speed
Take your foot off the pedal and press the DECEL/SET button when you reach the desired speed.
The moment you release the DECEL/SET button, the set speed is fixed, and cruise control begins. The CRUISE CONTROL indicator comes on.
To Adjust the Vehicle Speed
Increase or decrease the vehicle speed using the RES/ACCEL or DECEL/SET buttons on the steering wheel.
Each time you press the button, the vehicle speed is increased or decreased by about 1 mph (1.6 km/h).
If you keep the button pressed, the vehicle speed increases or decreases until you release it. This speed is then set.
To Adjust the Vehicle Speed
You can set the vehicle speed using the DECEL/SET button on the steering wheel when adjusting the speed with the accelerator and brake pedals.
To Cancel
To cancel cruise control, do any of the following:
- Press the CANCEL button.
- Press the CRUISE button.
- Depress the brake pedal.
The CRUISE CONTROL indicator goes off.
To Cancel
Resuming the prior set speed:
After cruise control has been canceled, you can still resume the prior set speed by pressing the RES/ ACCEL button while driving at a speed of at least 25 mph (40 km/h) or more.
You cannot set or resume in the following situations:
When vehicle speed is less than 25 mph (40 km/h)
When the CRUISE button is turned off
At vehicle speeds of 22 mph (35 km/h) or less, cruise control is canceled automatically.
See also:
Windshield Wipers and Washers
Windshield Wiper
1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers
Push the right lever up or down to select a position.
MIST - The wipers run at high ...
Towing a Trailer
Your vehicle has been designed primarily to carry passengers and their cargo.
You can also use it to tow a trailer if you carefully observe the load limits, use
the proper equipment, and follow th ...
Fastening a Seat Belt
After adjusting a front seat to the proper position, and while sitting upright
and well back in the seat:
1.Pull the seat belt out slowly.
2.Insert the latch plate into the buckle, then tug on ...