Audio System Theft Protection
The audio system is disabled when it is disconnected from the power source, such as when the battery is disconnected or goes dead.
■ Reactivating the audio system
Audio system without touch screen
1. Turn the ignition switch to ON ,
and turn on the audio system.
- If you turn the ignition switch to ACCESSORY
, you will be requested to
enter the audio security code.
2. Enter the audio security code using the preset buttons
Audio system with touch screen
1. Turn the ignition switch to ON ,
and turn on the audio system.
- If you turn the ignition switch to ACCESSORY
, you will be requested to
enter the audio security code. See step 3.
2. Press and hold the
(power/volume) button again for more than two
seconds.
- The audio system is reactivated when the system’s control unit recognizes that
the system is in your vehicle.
If the control unit fails to recognize, Enter code/Enter PIN Code appears on the audio/information screen.
3. Enter the audio security code using the touch screen.
All models
If you enter an incorrect digit, continue to the last digit, then try again. If you do not enter the code correctly after 10 tries, leave the system for one hour before trying again, or visit a dealer to have the system reset.
Find the audio system’s security code and serial number label in your owner’s manual kit.
We recommend that you write down the serial number in this owner’s manual.
Do not store the label in your vehicle. If you lose the label, you must first retrieve the serial number, and then obtain the code.
You can find out about your serial number and security code from a dealer.
U.S. models
You can register the security code at Owner Link (owners.honda.com.), and find information on how to retrieve the serial number and obtain the code at radio-navicode.honda.com.
See also:
Changing the Rear Wiper Blade Rubber
1. Raise the wiper arm off.
2. Pry on the edge of the lock tab using a flattip
screwdriver to push it up.
- Wrap the flat-tip screwdriver with a cloth
to prevent scratches.
3. Slide the wip ...
Compass Calibration
If the compass indicates the wrong direction, or the CAL indicator
blinks, you need
to manually calibrate the system.
1. Turn the ignition switch to ON
.
2. Press and hold the MENU button unti ...
Operating the System
If you do not operate the
system from the front panel for more than 20 seconds, the indicator in the button
goes off, and the front display returns to what has previously been displayed ...