Region Setting*

Honda Crosstour / Honda Crosstour 2010-2026 Owner's Manual / Features / Audio System / Region Setting*

The audio system’s region setting will be lost when the battery is disconnected or goes dead.

If the Region Select screen appears, you need to set the region for the audio system. Follow the steps below:

1. Press 2. Rotate to select the region you to select OK.
2. Rotate live in, then press .to select the region you live in, then press 3. You will receive a confirmation message on the screen. Rotate.
3. You will receive a confirmation message on the screen. Rotate then press to select Yes, then press The region setting is required only when the battery

The region setting is required only when the battery power is temporarily disconnected. It is set to your vehicle’s region type by the factory.

You cannot change the setting once you have completed the setting procedure. Contact a dealer if you selected an incorrect region.

These indications are used to show how to operate the MENU/SEL (Selector) knob or the interface dial.

Rotate to select.

Press Audio Remote Controls to enter.

    See also:

    Airbag Care
    You do not need to, and should not, perform any maintenance on or replace any airbag system components yourself. However, you should have your vehicle inspected by a dealer in the following situatio ...

    Changing the Rear Wiper Blade Rubber
    1. Raise the wiper arm off. 2. Pry on the edge of the lock tab using a flattip screwdriver to push it up. - Wrap the flat-tip screwdriver with a cloth to prevent scratches. 3. Slide the wip ...

    Customized Features*
    Use the audio/information screen to customize certain features. ■ How to customize Models without navigation system With the ignition switch in ON , press and hold the DISP button, then rot ...