Front Turn Signal/Parking Light Bulbs
When replacing, use the following bulbs.
Front Turn Signal/Parking: 24/2.2CP
Driver side
6-cylinder models
1. Unlock the holding clips, then remove the
upper part of the air intake duct and the air
intake tube.
Passenger side
All models
1. Remove the engine coolant reservoir.
2. Turn the socket to the left and remove it.
3. Push in the old bulb, rotate to the left until
it unlocks, and remove.
4. Insert new bulb
See also:
Emissions Testing
Testing of Readiness Codes
Your vehicle uses “readiness codes,” as part of its onboard self diagnostic
system.
Some states refer to these codes during testing to see if your vehicle’s
em ...
Checking the Engine
If the engine does not start, turn the ignition switch to START (e*1 and
check the
starter.
If you must start the vehicle immediately, use an
assisting vehicle to jump start it.
...
Automatic Transmission Fluid
Check the fluid level with the engine at normal operating temperature.
1. Park the vehicle on level ground.
Start the engine, let it run until the radiator fan comes on, then shut off the
engine ...