Power Windows
Turn the ignition switch to the ON (II) position to raise or lower any window. To open the window, push the switch down and hold it. Release the switch when you want to stop the window. To close the window, pull back on the switch and hold it.
The windows will operate for up to 10 minutes after you turn off the ignition switch. Opening either front door cancels this function.
Closing a power window on someone’s hands or fingers can cause serious injury.
Make sure your passengers are away from the windows before closing them.
AUTO - To open or close the driver’s window, push or pull the window switch firmly down or up to the second detent, and release it.
The window will automatically go up or down all the way. To stop the window, pull or push the window switch briefly.
When you push the MAIN switch in, the switch is off, and the passenger windows cannot be raised or lowered.
To cancel this feature, push on the switch again to get it to pop out.
Keep the MAIN switch off when you have children in the vehicle so they do not injure themselves by operating the windows unintentionally.
AUTO REVERSE - If the driver’s window senses any obstacle while it is closing automatically, it will reverse direction, and then stop. To close the window, remove the obstacle, then use the window switch again.
Auto reverse stops sensing when the window is almost closed. You should always check that all passengers and objects are away from the window before closing it.
NOTE: The driver’s window auto reverse function is disabled when you continuously pull up the switch.
See also:
Adjusting the Seat Positions
Adjust the driver’s seat as far back as possible
while allowing you to maintain full control of
the vehicle. You should be able to sit upright,
well back in the seat and be able to
adequately ...
Heating and Cooling System*
Using Vents, Heating and A/C
■Heating
The heater uses heat from the engine coolant
to warm the air.
1. Adjust the fan speed using the fan control
dial.
2. Select .
3. Adjust the tempe ...
How to Refuel
1. Stop your vehicle with the service station
pump on the left side of the vehicle in the
rear.
2. Turn off the engine.
3. Unlock the driver’s door using the lock tab
or the master door lock ...