Precautions While Driving
Driving Guidelines for Your Utility Vehicle
Utility vehicles have a significantly higher rollover rate than other types of vehicles. To prevent rollovers or loss of control:
Take corners at slower speeds than you would with a passenger vehicle.
Avoid sharp turns and abrupt maneuvers whenever possible.
Do not modify your vehicle in any way that you would raise the center of gravity.
Do not carry heavy cargo on the roof.
In Rain
Avoid driving in deep water and on flooded roads. This can damage the engine, driveline, or cause electrical component failure.
Other Precautions
If there is a strong impact with something under the vehicle, stop in a safe location. Check the underside of the vehicle for damage or any fluid leaks.
Precautions While Driving
NOTICE
Do not operate the shift lever while pressing the accelerator pedal. You could damage the transmission.
If the ignition switch is turned to ACCESSORY
or LOCK
while driving, the engine will shut
down and all steering and brake power assist functions will stop, making it difficult
to control the vehicle.
Do not put the shift lever in ,
as you will lose engine braking (and acceleration) performance.
During the first 600 miles (1,000 km) of operation, avoid sudden acceleration or full throttle operation so as not to damage the engine or powertrain.
Avoid hard braking for the first 200 miles (300 km). You should also follow this when the brake pads are replaced.
Driving Guidelines for Your Utility Vehicle
Failure to operate your vehicle correctly might result in a crash or a rollover.
See also:
Safety of Infants and Small Children
Protecting Infants
An infant must be properly restrained in a rear-facing, reclining child seat
until the infant reaches the seat maker's weight or height limit for the seat, and
the infant is ...
Tailgate
With all the doors unlocked, press the tailgate release button and lift open
the tailgate.
Models with the power tailgate
Press the power tailgate button on the driver’s door or the remote tran ...
Automatic Transmission Fluid
Check the fluid level with the engine at normal operating temperature.
1. Park the vehicle on level ground.
Start the engine, let it run until the radiator fan comes on, then shut off the
engine ...