Rear License Plate Light Bulb
When replacing, use the following bulb.
Rear License Plate Light: 5 W
1. Remove the lens by prying on the edge of the lens using a flat-tip screwdriver.
- Wrap the flat-tip screwdriver with a cloth to prevent scratches.
2. Remove the old bulb.
3. Insert a new bulb.
See also:
iPod®/USB Flash Drive
If an error occurs while playing an iPod® or USB flash drive, you may see the
following error messages. If you cannot clear the error error message, contact a
dealer.
Models without navigation sys ...
Off-Highway Driving Guidelines
General Information
Your vehicle has been designed primarily for use on pavement. But its higher
ground clearance allows you to occasionally travel on unpaved roads, such as campgrounds,
picnic s ...
Heating and Cooling System*
Using Vents, Heating and A/C
■Heating
The heater uses heat from the engine coolant
to warm the air.
1. Adjust the fan speed using the fan control
dial.
2. Select .
3. Adjust the tempe ...