Emergency Towing
If your vehicle needs to be towed, call a professional towing service or organization. Never tow your vehicle with just a rope or chain. It is very dangerous.
On 4WD models
The only way you can safely tow your vehicle is with flat-bed equipment. The operator will load Any other method of towing will damage the drive system. When you contact the towing agency, inform them a flat-bed is required.
your vehicle on the back of a truck.

Towing with only two tires on the ground will damage parts of the 4WD system. It should be transported on a f lat-bed truck or trailer.
On 2WD models
There are two ways to tow your vehicle:
Flat-bed Equipment - The operator loads your vehicle on the back of a truck. This is the best way to transport your vehicle.
Wheel-lift Equipment - The tow truck uses two pivoting arms that go under the front tires and lift them off the ground. The rear tires remain on the ground. This is an acceptable way to tow your vehicle.
If, due to damage, your vehicle must be towed with the front wheels on the ground, do this:
Start the engine.
Shift to D position and hold for 5 seconds, then to N.
Turn off the engine.
Leave the ignition switch in the ACCESSORY (I) position so the steering wheel does not lock.
Release the parking brake.

Improper towing preparation will damage the transmission. Follow the above procedure exactly. If you cannot shif t the transmission or start the engine, your vehicle must be transported with the all f our wheels of the ground.
With the front wheels on the ground, it is best to tow the vehicle no farther than 50 miles (80 km), and keep the speed below 35 mph (55 km/h).

The steering system can be damaged if the steering wheel is locked. Leave the ignition switch in the ACCESSORY (I) position, and make sure the steering wheel turns f reely bef ore you begin towing.
Refer to Towing Your Vehicle Behind a Motorhome for non-emergency towing information.
See also:
VSA® OFF Button
• The vehicle stability assist (VSA®) system helps stabilize the vehicle during
cornering, and helps maintain traction while accelerating on loose or slippery road
surfaces.
• VSA® comes on ...
Daytime Running Lights
The high beam headlights come on slightly dimmer than normal when the following
conditions have been met:
The ignition switch is in ON .
The headlight switch is off, or in
.
The lights rem ...
Heating and Cooling System*
● Rotate the fan control dial to adjust the fan speed and airflow.
● Press the Mode buttons ( /
/
/
) to select the vents air flows
from.
● Rotate the temperature control ...






