Brightness Control
When the parking lights are turned on and the ignition switch is in ON (w*1, you can use the brightness control knob to adjust instrument panel brightness.
Brighten: Turn the knob to the right.
Dim: Turn the knob to the left.
You will hear a beep when the brightness reaches minimum or maximum. The information display will return to its original state several seconds after you adjust the brightness.
■ Brightness level indicator
The brightness level is shown on the
information display while you are adjusting it.
Instrument panel brightness varies, depending on whether the exterior lights are on or off. The instrument panel dims to reduce glare when they are on.
Pressing the 
(Select/Reset) knob
switches the
display.
If you turn the knob to the right until the brightness display is up to max, the beeper sounds. This cancels the reduced instrument panel brightness when the exterior lights are on.
See also:
Changing the Rear Wiper Blade Rubber
1. Raise the wiper arm off.
2. Pivot the bottom end of the wiper blade up until it comes off from the wiper
arm.
3. Slide the blade out of the wiper.
4. Remove the retainers from wiper blade ...
Visual Index
*1: Models with the smart entry system have an ENGINE START/STOP
button instead of an ignition switch.
...
Fuel Recommendation
Your vehicle is designed to operate on unleaded gasoline with a pump octane number
of 87 or higher. Use of a lower octane gasoline can cause a persistent, heavy metallic
rapping noise that can lea ...