Seat Heaters
If equipped
Both front seats are equipped with seat heaters. The passenger seat only has heaters in the seat bottom because of the side airbag cutoff system.
The ignition switch must be in the ON (II) position to use the heaters.
Push the top of the switch, HI, to rapidly heat up the seat. After the seat reaches a comfortable temperature, select LO by pushing the bottom of the switch. This will keep the seat warm.
In the HI setting, the heater turns off when the seat gets warm, and turns back on after the seat’s temperature drops.
In the LO setting, the heater runs continuously. It does not cycle with temperature changes.
Follow these precautions when using the seat heaters:
Use the HI setting only to heat the seats quickly, because it draws large amounts of current from the battery.
If the engine is left idling for an extended period, do not use the seat heaters, even on the LO setting. It can weaken the battery, causing hard starting.
See also:
Transmission Fluid
■Automatic Transmission Fluid
Specified fluid: Honda ATF DW-1 (automatic transmission fluid)
Have a dealer check the fluid level and replace if necessary.
NOTICE
Do not mix Honda ATF DW-1 wi ...
Receiving a Call
When there is an incoming call, an audible notification sounds (if activated)
and the Incoming Call screen appears.
Press the button to answer the call.
Press the button to decline
or en ...
Opening and Closing the Moonroof
■Opening/Closing the Moonroof
You can only operate the moonroof when the ignition switch is in ON (w*1. Use
the
switch in the front of the ceiling to open and close the moonroof.
■ ...